Broan RP User Manual download pdf

AP1 & RP SERIES

Page 1

WARNING

CAUTION

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-

JURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufac-

turer. If you have questions, contact the manufacturer at the

address or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service

panel. Lock or tag service panel to prevent power from being

switched on accidentally.

3. Installation work and electrical wiring (including switch loca-

tion) must be done by a qualified person(s) in accordance

with all applicable codes and standards, including fire-rated

construction.

4. Provide sufficient air for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment

to prevent backdrafting. Follow the combustion equipment

standards such as those published by the National Fire Pro-

tection Association (NFPA), the American Society for Heat-

ing, Refrigeration and Air Conditioning Engineers (ASHRAE),

and local codes.

5. This product may have sharp edges. Be careful to avoid cuts

and abrasions during installation and cleaning.

6. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

7. Ducted fans must always be vented to the outdoors.

8. Use only metal ductwork.

9. As an alternative, this product may be installed with the UL-

approved cord kit designated for the product, following in-

structions packed with the

cord kit.

10. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may ig-

nite. Heat oils slowly on low or medium settings.

2. Always turn hood ON when cooking at high heat or when

flambeing food (i.e. Crepes Suzette, Cherries Jubilee, Pep-

percorn Beef Flambe).

3. Clean ventilating fans frequently. Grease should not be al-

lowed to accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for

the size of the surface element.

PROFESSIONAL STYLE

RANGE HOOD

READ AND SAVE THESE INSTRUCTIONS

FOR DOMESTIC COOKING ONLY

WARNING

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE

EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE

FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet,

or metal tray, then turn off the burner. BE CAREFUL TO

PREVENT BURNS. If the flames do not go out immediately,

EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PA N — Yo u may be burned or

spread the fire.

3. DO NOT USE WATER, including wet dishcloths or towels -

violent steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you

already know how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

1. Fo r indoor use only.

2. For general ventilating use only. Do not use to exhaust haz-

ardous or explosive materials and vapors.

3. For best capture of cooking impurities, range hood should be

mounted so that the bottom of the hood is 18”-24” above the

cooking surface.

4. Read specification label on product for information and re-

quirements.

Installer: Leave this manual with the homeowner.

Homeowner: Cleaning, Maintenance and Operating instructions on page 2.

NOTE These instructions are for ducted installations only.

If hood is to be installed non-ducted:

Purchase a non-ducted filter kit from your local distributor or

retailer. (Available for AP1 & RP2 Series hoods only.) Follow

instructions included with the non-ducted kit.

1 2 3 4 5 6 ... 15 16

Summary of Contents

Page 1 - RANGE HOOD

AP1 & RP SERIESPage 1WARNING CAUTION TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-JURY TO PERSONS, OBSERVE THE FOLLOWING:1. Use this uni

Page 2 - OPERATION

SÉRIES AP1 ET RPPage 10PIÈCES DE RECHANGE REPÈRE N° DE PIÈCE. DESCRIPTIONGARANTIE123456789101112121313161614151718192021222324242525262728293015 * Q

Page 3 - PREPARE THE HOOD

SERIE AP1 Y RPPágina 11ADVERTENCIA PRECAUCIÓN PARA REDUCIR EL RIESGO DE INCENDIOS, DESCARGAS ELÉCTRICAS O LESIONES PERSONALES, OBSERVE LAS SIGUIEN

Page 4 - INSTALL LIGHT BULBS

SERIE AP1 Y RPPágina 12LIMPIEZA Y MANTENIMIENTOPor motivos de desempeño, apariencia y salud, limpie el filtro, el ventilador y las superficies que ten

Page 5 - AP1 & RP SERIES

SERIE AP1 Y RPPágina 13CONDUCTO HORIZONTAL DE 3 ¼ PULG. X 10 PULG. (98,3 X 25,4 CM)FONDODEL GABINETEFRENTE DELGABINETE3/4 pulg.(1,9 cm)CUÑAS DE MADER

Page 6 - STYLE PROFESSIONNEL

SERIE AP1 Y RPPágina 145 Abra el agujero ciego del conducto vertical o el agujero ciego del conducto horizontal y fije el conector del regulador de t

Page 7

SERIE AP1 Y RPPágina 15PIEZAS DE REPUESTOCLAVE N.O PIEZA N.° DESCRIPCIÓNGARANTÍA123456789101112121313161614151718192021222324242525262728293015 1 9

Page 8

SERIE AP1 Y RPPágina 1699044040J

Page 9 - AVERTISSEMENT

AP1 & RP SERIESPage 2CLEANING & MAINTENANCEFor performance, appearance, and health reasons, clean filter, fan and grease-laden surfaces. Use o

Page 10 - SÉRIES AP1 ET RP

AP1 & RP SERIESPage 33¼” X 10” HORIZONTAL DUCTINGCABINETBOTTOMCABINET FRONTHORIZONTAL DUCTACCESS HOLE6¼"6¼"3/4"HOODMOUNTINGSCREWS (

Page 11 - ESTILO PROFESIONAL

AP1 & RP SERIESPage 45 Remove Vertical Duct Knockout or Horizontal Duct Knockout and attach Damper / Duct Connector with two (2) screws (supplied

Page 12 - Página 12

AP1 & RP SERIESPage 5SERVICE PARTSKEY NO. PART NO. DESCRIPTION 1 97017222 Feature Panel Weldment - RP-Black 97017223 Feature Panel Weldme

Page 13 - Página 13

SÉRIES AP1 ET RPPage 6AVERTISSEMENT ATTENTION AFIN DE RÉDUIRE LES RISQUES D’INCENDIE, DE CHOC ÉLECTRIQUE OU DE BLESSURES CORPORELLES, VE

Page 14 - Página 14

SÉRIES AP1 ET RPPage 7NETTOYAGE ET ENTRETIENPour des raisons de santé, de performance et d’apparence, nettoyez le filtre, le ventilateur et les surfac

Page 15 - GARANTÍA

SÉRIES AP1 ET RPPage 8CONDUIT HORIZONTAL 8,3 X 25,4 CM (3-1/4 X 10 PO.)DESSOUS DE L’ARMOIREAVANT DE L’ARMOIRECALES DE BOIS (armoires à dessous encast

Page 16 - Página 16

SÉRIES AP1 ET RPPage 95 Enlevez l’ouverture préamorcée verticale ou l’ouverture préamorcée horizontale et fixez le clapet / raccord de conduit avec d