EC62 SERIESINTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE INFORMATION ON PAGES 11 & 12.Broa
- 10 -17. REINSTALL FRONT PANEL AND WIRING COVERCAUTIONTake care not to pinch wiring when reinstalling the front panel and the wiring cover.Carefully
19. REINSTALL FILTERS1. Using a Phillips no. 2 screwdriver, assemble the knob to each filter.NOTE: The screw MUST BE on filter tabs side. See illustra
21. USE AND CARE (CONT’D)Power Pack CleaningStainless steel cleaning: Do:• Regularly wash with clean cloth or rag soaked with warmwater and mild soap
- 13 -24. WARRANTY23. WIRING DIAGRAMK1BLK BLACKBLU BLUEBRN BROWNGRY GREYORG ORANGERED REDWHT WHITEYEL YELLOWCOLOR CODELINEGROUNDNEUTRAL120 VACWHTBLKYE
- 14 -EC621306SS EC622301SS11HL01692342799101011KEYNO.PART NO. DESCRIPTIONQTY. (POWER PACK MODEL)EC621306SS EC622301SS1SV13296 ADAPTER/DAMPER 3¼” X 10
WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended
HL0126- 3 -- EC62 SERIES POWER PACK SYSTEM -3¼” X 10” ADAPTER/DAMPER(SUPPLIED WITH SINGLE BLOWERPOWER PACK)SINGLE BLOWER(600 CFM, SUPPLIEDWITH POWER P
- 4 -1. PREPARE THE INSTALLATION2. INSTALL DUCTWORK AND ELECTRICAL WIRINGPlan where and how the ductwork will be installed. Access to the top of the p
NOTE: The dual blower model has the same dimensions as the single blowermodel, but does not have a horizontal discharge. Refer to single blowerpower p
- 6 -5. CUT THE HOLE IN CUSTOM HOOD BASEIf it is not done yet, cut a hole in the bottom of the custom hood, using the dimensionsshown at right. NOTE:
- 7 -From inside the power pack, punch out the electrical knockout hole on top leftside (C) OR on back left side (D). Install the wire clamp (included
- 8 -Install 10” damper inside the VERTICAL ductwork that will be attached to power pack. Do not install in a horizontal ductwork or it will not open
- 9 -14. INSTALL THE POWER PACK (CONT’D)From inside the power pack, using provided no. 8-10 x 1/2” screws, mount the power packto the custom hood base
Comments to this Manuals