Broan E60E30SS Installation Guide download pdf (Page 12)

This hood requires 50 W max., 120 V with GU10 base, shielded halogen bulbs (not included). (2 required for 30" and 36" hood widths or

3 for 42" and 48" hood widths.)

1. Install bulbs by placing the bulb leads into their grooves in the socket.

2. Gently push upwards and turn clockwise until secure.

To remove bulbs, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.

NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.

Refer to instructions included with blower.

Plug the 3-prong plug cord from rough-in plate to the 3-prong male connector inside the

hood (A) and the 2-prong male connector cord from rough-in plate to the 2-prong plug inside

the hood (B).

16. INSTALL THE BLOWER (EXTERIOR OR IN-LINE BLOWER)

WARNING

Do not plug the 2 cords together.

HE0078

17. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS

HD0244

Reinstall grease drip rail. The illustration at right shows how to reinsert the grease drip rail

into the range hood.

CAUTION

Remove protective plastic film covering filters before installing them.

HD0245

It is recommended to install side filters first and finish

with center one(s).

1. Insert one end of the filter into the upper channel

of the hood.

2. Raise the other end toward the inside of hood

and insert in the grease drip rail of the hood.

18. INSTALL LIGHT BULBS

WARNING

Do not touch lamps during or soon after operation. Burns

may occur. In order to prevent the risk of personal injury,

only install shielded halogen lamps. Also, never install a cool

beam, a dichroïc lamp, a lamp not suitable for use in recessed

luminaires or identified for use in enclosed fixtures.

HO0090

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

No comments

Broan E60E30SS Installation Guide Page 12