Broan EW5836SS Installation Manual download pdf (Page 4)

MODELS EW5830SS • EW5836SS

Page 4

Flush with

the ceiling

Center of

installation

Upper flue mounting

bracket slots

Ceiling

INSTALL THE HOOD

(Ducted Hoods Only)

DUCT LENGTH

DECORATIVE

FLUE

6” ROUND

STEEL DUCT

1. Center the flue mounting bracket over the hood location and

flush with the ceiling. Secure the upper flue bracket to the

wall using (2) 4mm x 38mm mounting screws. Note: Drywall

anchors may be required (not included).

2. Tighten the screws completely. Make sure that the bracket is

tight against the wall and ceiling.

3. Remove the protective plastic film covering the decorative

flue and the hood at this time.

4. Remove the grease filters by pulling down the metal latch tab

and tilting filters downward to remove.

5. Align the two outer keyhole slots on the hood with the

mounting screws that were partially tightened into the wall

framing. Ensure that hood is seated entirely on mounting

screws and that hood is level. Then tighten screws completely.

6. Install (2) 4mm x 38mm long screws into the holes inside the

hood and tighten them securely.

7. Reinstall grease filters by aligning rear filter tabs with slots

in the hood. Pull down the metal latch tab, push filters into

position and release. Make sure filters are securely engaged

after installation.

8. Measure and install steel ductwork to hood duct connector

and ductwork rough-in on ceiling or wall. Use duct tape to

make all joints secure and air tight.

9. Plug power cord into wall outlet.

1 2 3 4 5 6 7 8 9 ... 27 28

No comments

Broan EW5836SS Installation Manual Page 4