Broan BC4130SS Installation Guide

MODELS BC2130SS & BC4130SSINTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE INFORMATION ON PAG

18. REINSTALL FILTER1. Rest rear filter edge on filter springs (A) in the powerpack.2. Using the finger cup, tilt up the filter into position. Makesur

- 11 -Avoid when choosing a detergent:- Any cleaners that contain bleach will attack stainless steel.- Any products containing: chloride, fluoride, io

- 12 -23.SERVICE PARTSBC2130SS BC4130SS11HL0134232454367885679101111131391212KEYNO.PART NO. DESCRIPTIONQTY. (POWER PACK MODEL)BC2130SS BC4130SS1 SV132

WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended

HL0133- 3 -- BC2130SS & BC4130SS POWER PACK SYSTEM -BC2130SSPOWER PACKSTANDARD3¼” X 10” ROOF CAP(NOT INCLUDED)STANDARD3¼” X 10” WALL CAP(NOT INCLU

- 4 -1. PREPARE THE INSTALLATION2. INSTALL DUCTWORK AND ELECTRICAL WIRINGPlan where and how the ductwork will be installed. Access to the top of the h

The recommended minimum thicknessfor the custom hood base is 5/8”. Thecustom hood sides and front thicknessare at the installer’s discretion.4. CUT TH

Using a Phillips no. 2 screwdriver, remove 4 screws retaining the inner panel to the power pack. See illustration below for screwlocations. Carefully

- 7 -11. REMOVE THE KNOCK-OUT OPENINGRemove the knockoutopening on top (verticaldischarge installation) or onback (horizontal dischargeinstallation) o

- 8 -14. INSTALL THE POWER PACKLift the power pack in custom hood until the bottom of the clasping springs (2 per side) rests on the top of the custom

- 9 -From the outside of the wall, using 2 no. 8 x 3/8’’ screws provided in partsbag, secure the adapter/damper to theback of the power pack. Remove t