Broan B5830SS Installation Guide download pdf (Page 6)

MODELS B5830SS • B5836SS

Page 6

INSTALL THE HOOD

(Non-Ducted Hoods Only)

NOTE: Non-ducted installations require Non-Duct Kit,

Model RK58 (purchase separately).

1. CAUTION: Do not use plastic or rigid metal duct.

2. Do not remove the protective plastic film covering the

decorative flue and the hood at this time.

3. Lay the back side of the hood flat on a table. Use a piece of

cardboard to avoid damaging the table or the hood.

4. Attach damper / duct connector to top of hood using (4) #8

x 3/8” Pan Head mounting screws.

5. Remove damper flaps from damper / duct connector and

discard flaps.

NON-DUCT KIT MODEL RK58 CONTENTS

8. Measure and install steel ductwork to hood duct connector.

Use duct tape to make all joints secure and air tight.

9. Hold hood up close to wall mounting location and plug

power cord into wall outlet.

10. Align the hood and center it above the hood mounting

bracket. Make sure ductwork on hood lines up and attaches

to ductwork in ceiling. Gently lower the hood until it securely

engages the bracket.

11. Use duct tape to make all joints secure and air tight.

INSIDE BACK OF HOOD

MOTOR/BLOWER

ASSEMBLY

HOLES

LOCATION

SIDE VIEW

Ø 5/16” TYP.

12. With the hood hanging in place, drill through both holes

located in the inside lower back of hood using a

⁄16” drill

bit. Insert the included drywall anchors into the drilled holes

(one for each hole). Install (2) washers and (2) #8 x 1-1/2”

mounting screws through the hood back and into the drywall

anchors. Verify that the hood is centered and leveled. Tighten

all screws completely.

13. Reinstall grease filters by aligning rear filter tabs with slots

in the hood. Pull down the metal latch tab, push filter into

position and release. Make sure filters are securely engaged

after installation.

14. Slightly push aside the upper flue to avoid any damage while

installing the lower flue to the hood top using (2) #8 x 3/8”

screws through the lower flue side slots.

15. Slide the upper flue upward until it is aligned with its mounting

bracket. The bracket should be inside the flue. Secure the

upper flue to the upper flue mounting bracket using (2) #8 x

3/8” mounting screws.

16. Remove protective plastic film covering the upper flue and

the hood.

UPPER

FLUE

UPPER FLUE MOUNTING BRACKET

DUCT LENGTH

DECORATIVE

FLUE

6” ROUND

STEEL DUCT

NON-DUCT

PLENUM

2 TIE

WRAPS

FLEXIBLE DUCT

NON-DUCTED

RECIRCULATION

FILTERS

NON-DUCT PLENUM

COLLAR

8 MOUNTING

SCREWS

(ST4 x 8

Round Head)

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Broan B5830SS Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Cooker hoods Broan B5830SS