Broan EW5836SS Installation Guide Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
MODELS EW5830SS • EW5836SS
Page 2
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where the ductwork will run between the hood and
the outside.
2. A straight, short duct run will allow the hood to perform most
efficiently.
3. Long duct runs, elbows and transitions will reduce the
performance of the hood. Use as few of them as possible.
Larger ducting may be required for best performance with
longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
NOTE
Centerline of duct connector on hood is ¾” to the left of the
centerline of the hood – plan duct rough-in accordingly.
MEASURE THE INSTALLATION
The minimum hood distance above cooktop MUST NOT BE
LESS than 24”.
A maximum of 36” above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 36” are at the installer and users discretion;
providing that the ceiling height permits.
PREPARE THE HOOD
HOOD
12
3
/
8
TO CENTER
OF
UPPER BRACKET
HOLES
ROUND
ELBOW
HOOD
MOUNTING
BRACKET
24” TO 36” ABOVE
COOKING
SURFACE
1
5
/8
DECORATIVE FLUE
6” ROUND DUCT
ROOF
CAP
WALL CAP
2” TO CENTER
OF
LOWER HOOD
CHASIS
HOLES
3½” FROM WALL TO
CENTER
LINE
OF
DUCT
(NOTE: CENTERLINE OF
BLOWER
IS ¾” LEFT OF
CENTERLINE
OF HOOD.)
DECORATIVE FLUE
Unpack hood and check contents. Yo u should receive:
1 - Hood Assembly
1 - Decorative Flue Assembly (consisting of upper and lower
flue)
1 - Upper Flue Mounting Bracket
2 - Aluminum Grease Filters (installed on hood)
2 - 35W MR16 GU10 Halogen Lamps (installed on hood)
1 - Parts Bag containing:
6 - Mounting Screws (4mm x 38mm Cross Recessed Pan Head)
2 - Mounting Screws (4mm x 12mm Cross Recessed Pan Head)
1 - Suction Cup Tool
1 - Installation Manual
6 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
Pan Head)
2 MOUNTING
SCREWS
(4mm x 12mm
Cross Recessed
Pan Head)
DECORATIVE
FLUE
ASSEMBLY
UPPER
FLUE MOUNTING
BRACKET
BULB
SUCTION
CUP TOOL
HOOD
ASSEMBLY
Page view 1
1 2 3 4 5 6 7 ... 27 28

Comments to this Manuals

No comments