Broan QL130BC Ql100 Series Specifications download pdf (Page 3)

PREPARATION

1. Use the dimensional drawings (Refer to FIGURES 1 - 3) to lay

out the range hood’s mounting holes, wiring access and duc-

twork by marking the cabinet bottom and drywall where appli-

cable.NOTE:Cabinetswithrecessedbottomswillrequirewood

shimstomakemountingsurfaceushwithcabinetframe.

2. Make cutouts for wiring and ductwork.

3. Ifthehoodistobeducted,installtheductworksothatisush

to the range hood’s mounting surface.

Refer to FIGURE 1 if the range hood is to be installed with a

horizontal discharge.

Refer to FIGURE 2 and FIGURE 3 if the range hood is to be

installed with a vertical discharge.

4. Runtwo-conductorwire(withground)fromapowersourceto

thehoodlocation.Bringapproximately12”ofwiringthrough

wiring hole in cabinet.

5. Drill four 3/32” diameter pilot holes at points where mounting

holes are marked in cabinet bottom.

6. Insertfour(4)mountingscrews,leavingapproximately¼”of

threadexposed.

7. Removeandretainthemountingscrewssecuringthe3¼”x

10” and 7” duct transitions to the hood. Install the appropriate

duct transition as described in the installation section.

INSTALLATION

1. Remove the necessary duct opening and wiring knockout from

the range hood.

If the range hood is to be installed as a non-ducted unit,

remove the wiring knockout only.

If the range hood is to be installed as a ducted unit,abafe

plateisprovidedtocloseoffthenon-ductedvent.Installbafe

plate (Refer to FIGURE 4) by sliding into place behind grille.

Use locator bumps to orient in grille.

2. For 7” round discharge installation, refer to FIGURE 5. Se-

cure 7” adapter (included) to top of hood using screws provided.

Install 7” round damper (Model BP87 (97010792), purchased

separately).

For 3¼” x 10” vertical discharge installation, refer to FIG-

URE 6.Secure3¼”x10”transition(ifused)totopofhood.

For 3¼” x 10” horizontal discharge installation, refer to

FIGURE 7.Ifusingsupplied3¼”x10”ducttransition,secure

it to the range hood. Ensure that the damper ap operates

fullyandfreely.Ifitdoesnot,removethedamperapormake

necessarymodicationstotheinstallationtoinsurefullandfree

operationofthedamperap.

3. Feed the wiring through the access hold and into the electrical

box.

4. Align hood’s keyhole mounting slots over the four (4) partially

installed screws.

5. Making sure the duct positions over the hood’s duct transition,

push the hood against the rear wall. Secure hood by tightening

screws.

6. Using a long blade screwdriver, reach into the discharge open-

ingand makesure the damperap operatesfreely(vertical

discharge only).

FIGURE 4

FIGURE 6

FIGURE 5

FIGURE 7

LOCATORS

BAFFLE

PLATE

7” ROUND

ADAPTER

(INCLUDED)

SECURE TRANSITION

WITH SCREWS

(INCLUDED)

POSITION DUCT

TRANSITION IN

WALL CUTOUT

HORIZONTAL

1 2 3 4 5 6

Comments to this Manuals

No comments

Broan QL130BC Ql100 Series Specifications Page 3

Comments to this Manuals

Related products and manuals for Cooker hoods Broan QL130BC Ql100 Series