Broan 61000 Series User Manual download pdf (Page 3)

- 3 -

6" ROUND

DUCT

ROOF CAP

6" ROUND

ELBOW

24" TO 30" ABOVE

COOKING SURFACE

WALL CAP

HOOD

DECORATIVE

FLUE

DEPTH ADJUSTMENT

SCREWS

L

L

C

5 "

7

8

5 "

7

8

to above cookto

p

30 "

5

8

36 "

5

8

FRAMING BEHIND DRYWALL

30

5

/8"= bottom of hood 24" above cooktop

36

5

/8"= bottom of hood 30" above cooktop

INSTALL THE DUCTWORK

NOTE: To reduce the risk of fire, use only

steel ductwork.

1. Decide where the ductwork will run between

the hood and the outside.

2. A straight, short duct run will allow the hood

to perform most efficiently.

3. Long duct runs, elbows, and transitions will

reduce the performance of the hood. Use as

few of them as possible.

4. Install a roof or wall cap. Connect 6" round

steel ductwork to cap and work back towards

hood location. Use duct tape to seal the joints

between ductwork sections.

INSTALL MOUNTING

BRACKETS

1. Construct wood wall framing that is flush with

interior surface of wall studs.

Make sure:

a) the framing is centered over installation

location.

b) the height of the framing will allow the

mounting brackets to be secured to the

framing within the dimensions shown.

2.

After wall surface is finished, secure mount-

ing brackets to framing using dimensions

shown.

INSTALL THE HOOD

3. Hang the hood from the brackets through the

rectangular cut-outs on the back of the

hood. Cut-outs are larger than the brackets

to allow for horizontal adjustment.

The bottom of the hood should be 24" to 30"

above the cooking surface.

4. Height adjustment screws provide vertical

adjustment.

5. Depth adjustment screws provide horizon-

tal adjustment.

6. Secure the hood with additional mounting

screws. Use drywall anchors, provided, if

wall studs or framing are not available.

WALL FRAMING

ADDITIONAL

MOUNTING

SCREWS

RECTANGULAR CUTOUTS

MOUNTING

BRACKETS

HEIGHT

ADJUSTMENT

SCREWS

ADDITIONAL

MOUNTING

SCREWS

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments