Broan ALLURE QS3 SERIES User Manual download pdf

Page 1

ALLURE

QS3 SERIES

RANGE HOOD

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY

TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If you

have questions, contact the manufacturer at the address or tele-

phone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel

and lock the service disconnecting means to prevent power from

being switched on accidentally. When the service disconnecting

means cannot be locked, securely fasten a prominent warning de-

vice, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment to pre-

vent backdrafting. Follow the heating equipment manufacturer’s

guideline and safety standards such as those published by the Na-

tional Fire Protection Association (NFPA), and the American Society

of Heating, Refrigeration and Air Conditioning Engineers (ASHRAE),

and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

6. To reduce the risk of fire or electric shock, do not use this range

hood with an additional speed control device.

7. Ducted fans must always be vented to the outdoors.

8. To reduce the risk of fire, use only metal ductwork.

9. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boilovers

cause smoking and greasy spillovers that may ignite. Heat oils slowly

on low or medium settings.

2. Always turn hood ON when cooking at high heat or when cooking

flaming foods.

3. Clean ventilating fans frequently. Grease should not be allowed to

accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for the size

of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT

OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal

tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.

If the flames do not go out immediately, EVACUATE AND CALL

THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN — You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels - violent

steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you already

know how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

ALLURE

QS3 SERIES

RANGE HOOD

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with

the homeowner.

Homeowner: Operating and

Cleaning information on page 5.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazard-

ous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

3. For best capture of cooking impurities, your range hood should

be mounted so that the top of the hood is 24-30” above the cook-

ing surface.

4. Please read specification label on product for further informa-

tion and requirements.

TABLE OF CONTENTS

This manual is divided into sections as follows:

• “PREPARE HOOD LOCATION”

Run ductwork from roof or wall cap, and electrical wiring from

service panel - to installation location

• “PREPARE THE HOOD”

Get your hood ready for installation

• “CONNECT WIRING”

Make electrical wiring connections to hood

• “INSTALL HOOD”

Secure hood to cabinet and ductwork - install bulbs and filters

• “OPERATION”

How to use the hood controls

• “CLEANING”

Keep your hood in top working condition

• “SERVICE PARTS”

Part numbers and exploded view of hood components

• “WARRANTY”

One-year limited warranty and how to contact us

NOTE If hood is to be installed Non-Ducted:

• Purchase a set of (2) non-ducted filters from your

local distributor or retailer and attach them to the

aluminum mesh filters.

1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - RANGE HOOD

®Page 1ALLURE® QS3 SERIESRANGE HOOD!WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURYTO PERSONS, OBSERVE THE FOLLOWING:1. Use this unit onl

Page 2 - PREPARE HOOD LOCATION

®Page 10ALLURE® QS3 SERIESRANGE HOODPágina 10CAMPANA EXTRACTORASERIE QS3 ALLURE®7 Sólo para descargas con conductos de 8.3 cm x 25.4 cm (3¼” x 10”): Q

Page 3 - PREPARE THE HOOD (Continued)

®Page 11ALLURE® QS3 SERIESRANGE HOODCAMPANA EXTRACTORASERIE QS3 ALLURE®OPERACIÓN1 Cuelgue la campana de los (4) tornillos de montaje (que seencuentran

Page 4 - CONNECT WIRING

®Page 12ALLURE® QS3 SERIESRANGE HOOD125681011157169417192033121314321222324252692729318283031CAMPANA EXTRACTORASERIE QS3 ALLURE®626893AGARANTIAPIEZAS

Page 5 - CLEANING

®Page 2ALLURE® QS3 SERIESRANGE HOODCABINETBOTTOMCABINET FRONTHORIZONTAL DUCTACCESS HOLE5¼"5¼"7½"1/8"¾"1315/16" (30"

Page 6 - SERVICE PARTS

®Page 3ALLURE® QS3 SERIESRANGE HOODPREPARE THE HOOD (Continued)4 Remove Damper/Duct Connector from inside the hood.Set connector aside - with mounting

Page 7 - SERIE QS3

®Page 4ALLURE® QS3 SERIESRANGE HOODCONNECT WIRINGWARNING: To reduce the risk of electric shock,make sure power is switched off at the servicepanel. Lo

Page 8 - (continuación)

®Page 5ALLURE® QS3 SERIESRANGE HOODINSTALL HOODWARNING: To reduce the risk of electric shock,disconnect from power supply before cleaning.Aluminum mes

Page 9

®Page 6ALLURE® QS3 SERIESRANGE HOOD125681011157169417192033121314321222324252692729318283031626893AWARRANTYBROAN-NUTONE ONE YEAR LIMITED WARRANTYBroan

Page 10 - CONEXIÓN ELÉCTRICA

®Page 7ALLURE® QS3 SERIESRANGE HOODPágina 7CAMPANA EXTRACTORASERIE QS3 ALLURE®!ADVERTENCIAPARA REDUCIR EL RIESGO DE INCENDIO, CHOQUE ELECTRICO,O LESIO

Page 11 - LIMPIEZA

®Page 8ALLURE® QS3 SERIESRANGE HOODPágina 8CAMPANA EXTRACTORASERIE QS3 ALLURE®TORNILLOS PARA EL MONTAJE DE LA CAMPANA (4)12.7 cm35.4 cm (campana de 76

Page 12 - PIEZAS DE SERVICIO

®Page 9ALLURE® QS3 SERIESRANGE HOODPágina 9CAMPANA EXTRACTORASERIE QS3 ALLURE®4 Quite el conector del regulador de tiro/conector delinterior de la cam