Broan Elite 15SSEXF Service Manual download pdf (Page 30)

Section D – Electrical Components

Remove two Phillips head screws and wire leads 3.

from the capacitor.

Discharge the capacitor (see Warning above).4.

Use an ohmmeter or multi-meter set on the “Ohms 5.

times 1000” scale (if available) to check resistance

across the wire terminals. The needle should jump

toward zero ohms and quickly move back to innity.

(NOTE: Some less-sophisticated meters will only tell

you if the capacitor is good or bad.)

If the needle does not move, if the needle reads a 6.

constant value or near zero ohms, or if the needle

jumps toward zero and then moves back to constant

high resistance (not innity), replace the capacitor.

Installation is the reverse of removal.7.

NOTE: On installation, route the wires through the notches

in the shield.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Broan Elite 15SSEXF Service Manual Page 30