Broan Elite 15SSEXF Service Manual download pdf (Page 12)

Section B – Cabinet

Gasket Assembly

REMOVE AND RE-INSTALL

The gasket is made of a exible vinyl material with

imbedded magnets. Over time it may become brittle or

cracked, and lose its exibility. If this happens the door

may not close properly, so replace the gasket.

CABINET

GASKET

RETAINER

STRIPS

SCREWS

TRIM

COVER

Remove door assembly (see Door Assembly, Remove 1.

and Re-install).

Remove control panel (see 2. Electrical Components,

Control Panel Assembly).

Lift the outer edge of the gasket to expose the 3.

retainer strips and the screws that are used to fasten

the strips to the cabinet. NOTE: There are six retainer

strips: two each on the top and bottom and one each

for the left and right sides.

Remove the Phillips head screws that secure the 4.

retainer strips to the cabinet; then remove the strips

from underneath the gasket. Pull the gasket off of the

cabinet.

To install a new gasket, place retainer(s) under the 5.

outer edge of the gasket, then use the screws to

fasten the retainers and gasket to the cabinet.

Re-install the control panel.6.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

No comments

Broan Elite 15SSEXF Service Manual Page 12