Broan E661 Installation Manual

MODEL E661INTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE INFORMATION ON PAGES 7 AND 8.Broan-NuT

9. OPERATIONC. OFF BLOWER / FILTER MAINTENANCE SWITCH:Press this switch to turn off the blower. Pressing this switch also cancels the delay function (

- 11 -11. WIRING DIAGRAM10. USE AND CAREGrease filters and bottom panel.The grease filters and the bottom panel should be cleaned frequently. Use a wa

HL0052- 12 -12. SERVICE PARTSE661 MODELKEYNO.PARTNO.DESCRIPTIONWIDTHS30” 36”1 T461 ADAPTER/DAMPER 112 V06118 ELECTRONIC CONTROL 113 V05917 LAMP SOCKET

WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended

- 3 -TABLE OF CONTENTS1. INSTALL DUCTWORK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

- 4 -1. INSTALL DUCTWORKPlan where and how the ductwork will be installed.Install proper-sized ductwork, elbows and roof or wall cap. Use 2” duct tape

- 5 -2. PREPARE THE INSTALLATION (CONT’D)Cut-out the openings for duct (A) and power cable (B), in cabinet or wall, according to the direction of disc

3.8 Using the 3 screws removed from 3.5, install the metal shutoff plateon top of the hood.3.7 From the top of the hood, slide out the plastic air dev

- 7 -4. INSTALL THE ADAPTER/DAMPERThe wall duct must be roughed-in to properly interface with the hood. Before performing the installation, make sure

- 8 -5. INSTALL THE HOOD6. CONNECT WIRINGConnect cable into wiring box using provided wire connectors.Connect wires as follows: BLACK to BLACK, WHITE

- 9 -8. LIGHT BULBSThis hood must use 120 V, 50 W max., type MR16, GU10 shielded halogen lamps. (Purchase separately).NOTE: The rings must be removed