Broan ALLURE QS2 Series User Manual download pdf (Page 4)

Page 4

ALLURE

QS2 SERIES

RANGE HOOD

PREPARE THE HOOD

13 3¼” x 10” Ducted Discharge Only: Remove Tape from damper

flap and attach Damper/Duct Connector over knockout

opening with screws removed in Step 4 under “PREPARE

THE HOOD”. Make sure damper Pivot is nearest to Top/Back

Edge of hood.

DAMPER/

DUCT

CONNECTOR

(Vertical

discharge

position shown)

TAPE

UP TO 1”

SIDE-TO-SIDE

ADJUSTMENT

PIVOT

TOP/BACK

EDGE

NOTE Damper/Duct Connector can be installed up to 1-inch

on either side of hood center - to accomodate off-center

ductwork. In extreme off-center installations, one end of

the duct connector may need to be trimmed to clear the

electrical cable clamp.

PREPARE THE HOOD

11 Remove appropriate Duct Knockout(s) from top or back of

hood.

REAR

RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10”

Horizontal Discharge)

TOP RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10”

Vertical

12 Horizontal Discharge Only: Remove the Plate in front of the

horizontal discharge knockout. Cut the Ties, lift plate out,

and discard plate. DO NOT REMOVE the Metal Strip held

in place with two Screws.

TIES

PLATE

METAL STRIP

SCREW

10 Non-Ducted Installations Only: Require a Performance Ring

to be attached to the blower wheel.

To install ring:

1. Remove the Blower Wheel by rocking it side to side and

applying a slight force to pull wheel from motor. Remove

Retaining Ring if necessary.

2. Slide the ring onto the Small Diameter End of the wheel

and down to the Stop Edge of the wheel.

3. Reassemble wheel to motor. Make sure Tab on wheel fits

into one of the Motor Slots.

4. Push wheel down until it is locked in place.

5. Check that wheel is properly positioned as shown. Press

Sections into place if necessary. Make sure wheel turns

freely.

BLOWER

WHEEL

TA B

SECTIONS

SMALL DIAMETER

END

STOP

EDGE

RING

MOTOR

SLOTS

RETAINING

RING

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Broan ALLURE QS2 Series User Manual Page 4

Comments to this Manuals

Related products and manuals for Cooker hoods Broan ALLURE QS2 Series